How to connect the rf receiver to a switching system???

Electronics & Electrical Engineering Topics

How to connect the rf receiver to a switching system???

Postby Prashanth » Wed Oct 15, 2014 9:35 am

In the rf module, the encoded signal is sent to the receiver and it will be decoded thereafter...
After decoding, what really happens???
And how to use the decoded signal as if to connect it to a switching system???

[ Post made via Mobile Device ] Image
User avatar
Prashanth
 
Posts: 1
Joined: Wed Oct 15, 2014 8:56 am
Cash on hand: 159.20

Invitations sent: 0
Registered friends: 0
Reputation point: 0
Lance Corporal

Re: How to connect the rf receiver to a switching system???

Postby SevenZero » Wed Oct 15, 2014 2:41 pm

You need to define your own messaging protocol. An example is given below.

RELAY1ON
RELAY2ON
RELAY1OFF
RELAY2OFF

ON reception of these messages, a message decoder then calls relevant On/Off functions of the microprocessor/controller.
User avatar
SevenZero
Support Team
Support Team
 
Posts: 286
Joined: Sun Nov 01, 2009 3:07 pm
Cash on hand: 201,474.40

Invitations sent: 0
Registered friends: 0
Reputation point: 10
Corporal


Return to Electronics & Electrical Engineering

Who is online

Users browsing this forum: No registered users and 1 guest